The Origin Forum

The Origin Forum

All Forums

Origin Forum

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:

UserName:

Password:

Anti-Spam Code:

Format Mode:

Format:

Message:

* HTML is OFF
* Forum Code is ON

Check here to include your profile signature.
Check here to subscribe to this topic.

T O P I C R E V I E W
tantiger	Posted - 06/21/2000 : 10:37:00 PM I have installed SR1 to SR4 for my origin 6. Before I installed SR1, I can do differentiation correctly. After that, I found the result is not correct. Try this: first, draw a sine curve for 0 to 360 degree, 2nd, from analysis choose caculus then differentiation, you will see the result has an amplitude of 0.02, which is 50 times smaller than the original sine curve (which is 1.0). Anybody can help me for that? Thank you very much!! ------------------
2 L A T E S T R E P L I E S (Newest First)
rtoomey	Posted - 06/26/2000 : 1:05:00 PM Tantiger and Jose, In response to your interest in how our differentiation feature works, a Knowledge Base item has been prepared. Please take a look at it since it should clear up any confusion. If you would like to link to it directly, please click here. Sincerely, Ryan Toomey [This message has been edited by rtoomey (edited 06-26-2000).] [This message has been edited by rtoomey (edited 06-26-2000).] [This message has been edited by rtoomey (edited 06-26-2000).] [This message has been edited by rtoomey (edited 06-26-2000).] [This message has been edited by rtoomey (edited 06-26-2000).] [This message has been edited by rtoomey (edited 06-26-2000).]
Jose	Posted - 06/22/2000 : 8:04:00 PM I cannot reproduce that error on my SR2, though the problem sounds familiar to me (as if I had pass it long time ago...) jose.

The Origin Forum