| T O P I C R E V I E W |
| schneide |
Posted - 03/17/2005 : 09:05:46 AM
I get the above error message when starting origin
As posted in Topic 3756 I found the following linker error
C:\C\Vc32\originc\originlab\ImportWiz.c(4339) :Fehler, Die Funktion fuSetHeaderParamDefined@_KGHA wurde aufgerufen. Während des Linkens konnte der Funktionskörper aber nicht gefunden werden.
Linking Failed!
How do I proceed from here ? where to find and/or place the missing file?
Gi
Giselher |
| 3 L A T E S T R E P L I E S (Newest First) |
| schneide |
Posted - 03/21/2005 : 10:27:46 AM
You were right the message said that the linker couldn't find the function body of....
Thanks for your advice,however I was not lucky in fixing the problem by following your suggestions, so
I did a complete reinstall (including a removal of the origin folder) to remedy the problem.
Hope it doesn't show up again when I will continue to work on those origin c projects that may have caused the trouble....
Gi |
| Gary Lane |
Posted - 03/17/2005 : 10:16:12 AM
Hi again,
Something is most likely wrong with your startup workspace..either startup.ocw or filter_utils.c (the source file containg the body of the function fuSetHeaderParamDefined) is missing or corrupted.
You could:
1. Make sure the files filter_utils.c and .h exist in your OriginC\OriginLab\ folder and that filter_utils.c is listed in the file startup.ocw (do a File:Open Workspace menu item and open OriginC\OriginLab\startup.ocw).
2. Or, try doing a re-install or repair of Origin,
2. Or, tell me your exact build and email address and I will send the needed files.
Gary,
OriginLab
Edited by - Gary Lane on 03/17/2005 10:40:19 AM |
| Gary Lane |
Posted - 03/17/2005 : 09:40:07 AM
Hi,
If you need to use Origin right away I suggest renaming the file OriginC\Originlab\startup.ocw until we figure out what is wrong. You will have a less than complete Origin but will be able to do many things.
Would you mind translating the error message for me...I must admit my German is morethan a bit rusty. I suspect you are missing a file containing the function fuSetHeaderParamDefined which I will locate for you and then post here again.
Also please let me know the exact build of Origin you are using (Help:About Origin).
Thanks,
Gary
OriginLab
Edited by - Gary Lane on 03/17/2005 10:32:13 AM |
