| T O P I C R E V I E W |
| SMCA |
Posted - 05/12/2009 : 07:29:33 AM
Origin Ver. 8 and Service Release 5(Select Help-->About Origin):
Operating System: WinXP SP3
Dear all,
I used to employ the mask tool to hide outliers in my data both in scatter as well as in line+scatter graphs. In both cases masking, say, datapoint n and hiding this datapoint resulted in graphs where datapoints n-1 and n+1 were still visible and point n was invisible. In case of line+scatter graphs there was then no connection in between n-1 and n+1. Turning on "connect across missing data" checkbox resulted in a connection between n-1 and n+1.
After updating from SR3 to SR5, however, the masking tool works differently for line+scatter graphs. Apparently, the mask tool now just hides datapoint n WITHOUT hiding the line between (n-1 and n) and (n and n+1). Thus, although the outlier itself is removed, it is still indicated by the lines of the line+scatter plot (see attached image, arrow marks masked outlier)
Any suggestions to force the old behaviour are welcome.
Best,
Stefan
OriginPro 8SR3 B932 |
| 2 L A T E S T R E P L I E S (Newest First) |
| SMCA |
Posted - 05/13/2009 : 02:28:46 AM
Hi Easwar,
just tried it and edited my macros.cnf file. Works great! Thank you!
Best,
Stefan
OriginPro 8SR5 B987 |
| easwar |
Posted - 05/12/2009 : 10:56:08 AM
Hi Stefan,
Apologies for the inconvenience caused by this change of behavior - we will address this in upcoming SR6.
For now you can use the @FDL system variable. If you set that to zero (default in SR5 is 1), then you will get previous behavior.
So you can open script window and execute:
@fdl=0;
You could add this to your macros.cnf file for now.
Easwar
OriginLab |
|
|
