| T O P I C R E V I E W |
| a.abc.b35 |
Posted - 07/06/2011 : 12:42:08 PM
Origin Ver. and Service Release (Select Help-->About Origin): 8.5.1
Operating System:Win 7
..........
This is very elementary , I just don't know how to do it. Please help.
When I use Peak analyzer I generate a graph (shown below) after fitting with a function. Now what I want is only the part enclosed inside blue box. If someone can tell me what to omit in the peak analyzer (i guess it's in report section) to get the job done or how to copy only that part, say to MS power point, it will be very helpful. I shall prefer the 2nd solution but dont mind even if its the 1st one as all information are stored in the fit report sheet anyway. Here is the image :
AB |
| 3 L A T E S T R E P L I E S (Newest First) |
| a.abc.b35 |
Posted - 07/07/2011 : 03:29:05 AM
Thanks a lot to both of you.
AB |
| Deanna |
Posted - 07/06/2011 : 11:20:54 PM
Hi AB,
An easier approach could be:
1> First plot the data you want to analyze with (using any custom template or formatting etc that you desire)
2> Start the Peak Analyzer from the graph (instead of from the worksheet)
3> Peak Analyzer pops up a preview graph window for use while the dialog is open, which is fine
4> On the last Fit Peaks page, expand the "Results->Configure Graph" node, then change the "Create Report Graph" drop-down to "<Source Graph>", and make sure the "Fitted Curves Plot" check box is checked and the "Plot Curves" drop-down says "Both", meaning that both individual and cumulative peaks will be added.
Then when you click Finish, your original graph will contain the fit curves, and you can further customize the plot as desired, and copy paste or export etc.
Easwar
OriginLab
|
| Hideo Fujii |
Posted - 07/06/2011 : 1:17:50 PM
Hi AB,
Not sure why you want to extract the result plot in the report graph because the graph itself is stored in the worksheet (FitPeaks1) in the same workbook of the data. If you specifically want to extract the graph from the report graph, you can:
1) Click inside the plot in the report graph to show the layer bound yellow rectangle; and copy it (CTRL+C).
2) Open an empty graph window, and paste it (CTRL+V)
3) Press inside the empty axis frame, and press DELETE key.
4) Move and resize the pasted layer to show well.
I hope I didn't misunderstand what you meant.
--Hideo Fujii
OriginLab |
|
|
