The Origin Forum

The Origin Forum

All Forums

LabTalk Forum

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:

UserName:

Password:

Anti-Spam Code:

Format Mode:

Format:

Message:

* HTML is OFF
* Forum Code is ON

Check here to include your profile signature.
Check here to subscribe to this topic.

T O P I C R E V I E W
circumvent	Posted - 06/06/2007 : 5:51:24 PM Origin Version (Select Help-->About Origin): 7.5 Operating System: WinXP Does any one here knows to interpolate one dataset according to another dataset? The only command I found in Labtalk is "copy -s npts DS1 DS2" However, this command will interpolate the dataset evenly. I am thinking of doing calculations between two curves, (such as the simple math in origin). The natural way will interpolate Curve2 according to Curve1, then performing direct calculations. Does anyone here could give good suggestions/comments? Thank you very much in advance. Interpolating both dataset evenly won't work because dataset1 is not well distributed.....
2 L A T E S T R E P L I E S (Newest First)
circumvent	Posted - 06/07/2007 : 08:59:58 AM Thanks'f Mike's reply. http://www.originlab.com/forum/topic.asp?TOPIC_ID=5723 helped a lot.
Mike Buess	Posted - 06/06/2007 : 10:33:11 PM quote: I am thinking of doing calculations between two curves, (such as the simple math in origin). The Simple Math tool interpolates automatically. (Help> Origin> Analysis: Basics> Math Operations on Plotted Data> Performing Math Operations and Interpolating and Extrapolating). See also http://www.originlab.com/forum/topic.asp?TOPIC_ID=5723 Mike Buess Origin WebRing Member Edited by - Mike Buess on 06/06/2007 10:40:02 PM

The Origin Forum