Origin Ver. and Service Release (Select Help-->About Origin): 9.0.0
Operating System: Windows 7
Hello,
I have written code in which fitting (using nlsf commands, not X-functions, since pasting the parameters to the plot is more automated for the former commands) takes place in two separated loops. I set nlsf.constr$ in each loop (the constraints for each are different). I then get an "Attention!" message that reads "New or modified functions have not been saved." I always choose "Save all". Is there any way I can set some property such that I never see this message and "Save all" is always performed? The fit loops take quite a bit of time, so I would rather not have to check in at unpredictable intervals to click "save all" manually so that the calculation can continue. Thank you! |
Suppressing "New or modif. fxns. have not been..."
Posted - 01/24/2014 : 09:51:47 AM
