| Author |
 Topic  |
|
|
usman.arif3711
Pakistan
1 Posts |
 Posted - 02/05/2014 : 02:16:05 AM
|
Hi guys...
I am new to this forum. I was assigned a task from my supervisor.I have a low grade mems accelerometer, whose data is Y under some temperature values X (temperature is given using a hair dryer and measured with a sensor). I do curve fitting b/w X and Y and get coefficients, a0,a1,a2. Again the same accelerometer is given different temperature and get X and Y. Curve fitting them gives me another set of coefficients b0,b1,b2. Is there any way i could combine both results and get single set of coefficients for both cases.combining both test data,makes curve fitting inefficient....
asdf |
|
|
lkb0221
China
497 Posts |
Posted - 02/05/2014 : 10:19:59 AM
|
Hi,
In nonlinear fitting dialog, "settings" tab, "Data Selection" page, you can select "Concatenate Fit" for "Multi-Data Fit Mode".
This will put all xy together as one dataset and do the fit so only 1 set of parameters will be given.
Zheng
OriginLab
|
 |
|
| |
Topic |
|
|
|
Curve Fitting Proble