| Author |
 Topic  |
|
|
redspirit
Germany
45 Posts |
 Posted - 07/23/2017 : 05:35:16 AM
|
Origin Ver. and Service Release (Select Help-->About Origin): 2017 (64 bit) SR2, b9.4.2.380
Operating System: W7 64 bit
Is there any possibility to switch back to old layer contents dialog view (with ticks)? The new one is absolutely non-convenient as soon one has data with large number of columns and with error bars, which are not in neighboring columns. With ticks in previous version it was very clearly what I choose and I could choose graph with error bar in one step.
In addition with new Dialog it becomes complicate to make such as simple procedure as replacing data connected to the curve: for example I plotted column7, then I looked on it, decided to normalize data while keeping the original. The I created column8, add a function to it. With old layer content dialog it was necessary only to change one tick. In new one- several steps.
Dear Origin-Team, please, take into account users, who works with large and complex data sets, and not only those who has one ColumnX and one ColumnY, as in your video on youtube. |
Edited by - redspirit on 07/23/2017 05:51:40 AM |
|
|
JacquelineHe
287 Posts |
|
|
redspirit
Germany
45 Posts |
Posted - 08/23/2017 : 4:19:49 PM
|
I am sorry, Jacqueline, this is my mistake. The problem was that after installation of the SR the "plot setup" window was shown in short form with both upper parts (including those one with ticks) minimized. I have not seen the button "blue double arrow" at the upper right corner to maximized this parts of the "plot setup" window. This button is shown with red arrow in the picture below.
Therefore I thought that with new SR the data can be added only by "Layer Contents" dialog-window which is not good in case of large set of structured data.
Finally I found the "blue double arrow" button and now the "plot setup" window looks as it should allowing for easy manipulation with data:
 |
 |
|
| |
Topic |
|
|
|
Old Layer Contents Dialog